Light Kits for LEGO® Star Wars™, Lit for the Galaxy

The LEGO® Star Wars™ Ultimate Collector Series (UCS) Millennium Falcon can be lit as you build, or if you have already built your LEGO® masterpiece, you can illuminate your already built Millennium Falcon with the 20 galactic lights using the "Light After Build" instructions.

Yes, Light My Bricks supplies specific lightsaber component packs and minifigure accessories that illuminate trans-colored blades with high-intensity LEDs. These components use 0.2mm ribbon-thin flat cables to connect into your set's main power hub.

Yes. Light My Bricks makes lighting for LEGO® Star Wars™ helmets as light kits and DIY light bundles, including the Darth Vader™ Helmet #75304, Kylo Ren™ Helmet #75415 and Jango Fett™ Helmet #75408. Each has base spotlights that shine up onto the helmet, highlighting its key features.

Wires are hidden by routing 0.2mm ribbon-thin flat cables through existing Technic beam gaps and under exterior hull plates. The cables are engineered to fit snugly inside the brick channel, keeping wiring discreet and maintaining the structural integrity of the vehicle.

Yes, Light My Bricks provides all-in-one, set-specific light kits engineered specifically for large-scale Star Wars™ models. Each kit includes a variety of LED lights suitable to the set, connectors, and 3D digital instructions, with most kits offering instructions for both Light As You Build and Light After Build installations, so you can light a set you have already built.

Light My Bricks kits are dedicated LED lighting systems engineered specifically for LEGO® sets. Each kit uses 0.2mm ribbon-thin flat cables designed to fit between LEGO® studs and plates without gaps, and reverse polarity connectors that plug in at any orientation.

Light My Bricks light kits run on a low-voltage 5V, 2.4A USB input. For continuous display, connect the kit to a Light My Bricks USB Wall Adapter, which powers up to 400 LEDs in total across its two USB ports, or to a Light My Bricks USB Power Bank. For mobile displays, the Flux Pack uses 6x AAA batteries and has a 4-stage dimmer for medium-sized kits, and the compact Power Brick 2.0 uses 2x CR2032 batteries to power up to six LEDs when combined with docks. Light My Bricks recommends only its own power sources. Other adapters, including higher-voltage ones, are used at the customer's own risk and are not covered by warranty.

Light My Bricks kits cost more than generic LED options because each kit is a complete lighting system researched and designed for one specific LEGO® set. Each kit uses 0.2mm ribbon-thin flat cables that tuck inside brick channels, brick-compatible components that clutch onto LEGO® studs with no glue or adhesive, built-in smart fuse protection, components certified to CE, UKCA, FCC, RCM and RoHS standards and set-specific light effects, with 3D instructions written for that build. Our manufacturers are also audited to Sedex and BSCI ethical trade standards.

Light My Bricks kits can be installed during or after the build, and the finished result is identical. Light As You Build suits a set that has not been started: follow the Light My Bricks 3D guide from the first brick and each lighting component is added at the point it fits most cleanly, so the set is fully lit when the last brick goes on. Light After Build is for completed sets, with no time limit, including sets built years ago. The guide shows which large sections to separate and in what order.

No, Light My Bricks light kits are completely non-destructive and fully reversible. Components clutch onto LEGO® studs with no glue or adhesive, so nothing can damage or discolor the bricks. The 0.2mm ribbon-thin flat cables run inside the brick channels without forcing, modifying, or gluing any original pieces, and removing the lighting leaves the set exactly as it was.